Diablo VT Roadster heading
CARS WALLS NEWS TUNING CONCEPTS EVENTS MOVIES AUCTIONS CONTACT

Diablo VT Roadster

Diablo VT Roadster

By Mark Smeyers on January 1. 2010 in Diablo.

On the 1992 Geneva Auto Show, Automobili Lamborghini SpA presented a prototype of an open-top version of their flagship, the Diablo Roadster, but it took another three years of work and development to have the Diablo VT Roadster ready for sale.

It was however a little reworked; it was not quite the same car as the prototype three years earlier. The bodywork was altered; the side-air intakes used a design similar to the one seen on the Diablo SE model, with the two vertical slots leading air onto the rear disk brakes.

The front spoiler was completely redesigned to distinguish the VT Roadster from it's 'normal' closed counterparts, the fog lights were now separated, two rectangular lights and two circular lights were used instead of the four square units on the closed Diablo. Also, twin air intakes were mounted next to these rectangular lights to guide air onto the front disk brakes.

The rear bumper used a design similar to the one used for the SE model, this way the backup light and the rear fog lights were built into the bumper, the grille between the rear taillights was also close to the SE styling grille. The VT Roadster now used four oval exhausts instead of the earlier round ones.

The engine cover needed to be redesigned, together with the bodywork behind both passengers, because that's were the roof was stored when not in place above the driver. This roof section was made of carbon fiber to keep the weight down, but Lamborghini was going to offer an electric system to open and close the roof. This system would be developed in association with the Swiss Lamborghini importer Affolter (see the GT section). When the roof was stored in the engine lid, it did not remain open when accessing the engine, you would have to put the top back in place when checking the oil.

The last thing you'd notice on the outside were the specially designed rims, 17 inch tall front and rear, also with the three-piece design, but slightly different from the original Diablo ones. By the way, the Roadster was only available in VT version; an SV Roadster with rear wheel drive was developed by the factory, but only very few were ever made, and all on special order.

On the inside, the Roadster was much like the latest Diablo VT from which it used the entire dashboard configuration, one thing was unique for the Roadster however, the seats were slightly modified and used a completely different stitching for the seat and backrest. In addition, the leather used was especially selected for the Roadster, since the possibility of rain was always present and the leather would have to resist to direct sunlight too when driving top-less, for which the Roadster was intended of course.

Print this article

DMC Exotic Car Tuning

Lamborghini Club America

sponsoring